Tar and most oil based products are not directly compatible with water based products.
I don’t know the following for a fact since I wasn’t there when the work was done, but I’d bet large sums of money emulsifier was not used in the following situations. If it was used then it wasn’t used properly.
In the photo below, extra tar was used along the drip edge. The more tar used, the more oil there is. The additional oils from the thicker tar caused the coating to fail along the edges before failing elsewhere.
Thicker tar again. Notice the spot the the upper right. Its doing better. When oil from the tar is going to cause a failure in the coating it almost always happens sooner in the areas with thicker tar.
More tar along the edges. Failed here first and then started failing elsewhere. This roof needed repair work a few years prior to this photo being taken.
I doubt any emulsifier was used on this roof at all prior to putting on the tan cool coating. My guess is additional patch work was done around the skylights at a later date.
Alligator cracking also called mud cracking. More emulsifier would have helped in the thick area by my business card. This spot was probably still going to dry out and crack anyways, as areas with lots of tar keep drying out for years. As they dry out they shrink and crack. The give away here is the rest of the roof. Its also drying out. No emulsifier or not enough emulsifier.
Alligator crack. This spot was going to crack and not much to be done with it other than to recoat. The area around it is also cracking out and it shouldn’t be.
More alligator cracking.
The entire roof looked like this. The coating was having adhesion issues.
1011 S Eli drive. Tucson AZ. 85710
Bonded and Insured.